How do I change a light bolb?

Question

How do I change a light bolb?

Answer 1

Stick your tongue in the socket to make sure the bulb goes in smoothly and that should do it.You silly girl I know you knew that!!!

Answer 2

ok first of all turn off the light, leave it for about 3-4 mins and let it lose it heat. then get the light and its holder(holder in your left hand and bolb in your right hand) and turn the bolb from left to right(as the clocks pointers turn).buy the same bolb and do the reverse.

Answer 3

Take it as a project and follow tese steps.



Step zero: check the bulb type and buy a new light bulb.

Step one: (switch off the bulb) turn off the electricity.

Step two: wait for bulb to cool down (5- 10 minutes).

Step three: take a towel and hold the bulb.

Step four: while holding the holder, turn the bulb counter-clockwise (Depends if it's a two pin head or a screw bulb).

Step Five: take a new bulb or bulb from some other place.

Step Six: fix the bulb in the holder and rotate the bulb clockwise.

Step seven: check if bulb is properly fixed.

Step eight: (switch on the bulb.) turn on the electricity.

Answer 4

Well first i think u mean light Bulb right? Well since u aren't here to answer that question i am going to tell u how to do it. Get a light bulb make sure it isnt too strong for the lamp or socket. It tells u in your lamp what kind of light bulb to use.....unscrew the light bulb from the light socket(the bad one), make sure u dont burn your hand by doing this. Move quickly so u dont burn your hand and lay it aside and then take the new one and aline it to the socket and screw it in! I just know u can do this! lol

Answer 5

how ho you think?





you have great indications in the other messages. but never forget... to change a light bulb u need to ask everyone but not an specialist. ok?

take care!

Answer 6

Call a handy repairman @ 15 per hr to chnage it for you.

Answer 7

First thing you need to learn to do is spell...then go find a new lightbulb...unscrew the old one, put the new one in and screw it in. Good luck.

Answer 8

use somethin' to hold the light bulb, don't use your hand, coz' the grease on it might make the bulb die easier. then screw the bulb in

Answer 9

Make sure it's not on. They tend to be warm or extremely hot when in use. And unscrew it.

























...jesus.

Answer 10

ask a woman

Answer 11

Very funny, ********.